Freshly cast pendulum support

Newly cast pendulum support.

The pendulum support has been cast and we’ve just got it back from the foundry. It’s not quite finished yet though. It needs a bit of light sanding to remove some of the casting marks on the edges. Then it needs the bottom of the two feet flattening so it sits nicely on the clock’s frame, plus bolt holes drilling. Recessed areas needs to be milled to mount brass plates on the front and back. Finally, a v-shaped groove needs to be cut across the top for a small bar to sit in,  from which the pendulum actually hangs. This is another significant chunk (literally) of the clock done, or almost done, and allows further progress to be made on building the new escapement.